Avaya G700 Installation And Upgrades page 167

5
Log off.
Configure an SNMP Community String for Traps
Configuring the G700 Media Gateway to send SNMP traps to the primary server can be accomplished by
two commands:
•
P330 stack processor CLI command
•
Media Gateway Processor (MGP) CLI command
SNMP requires community strings to be used for each SNMP 'request'. You can set only three
community strings on the G700 — one each for read requests, write requests, and traps. The command
for traps is:
set snmp community trap [community string]
1
Telnet to the P330 stack processor.
2
Log in as
3
At the P330-1(super)# prompt, type
.
Enter
4
Type exit
Configure the Destination for G700 SNMP Traps
Events occurring on the G700 cause SNMP traps to be generated. The G700 MGP can be configured to
send SNMP traps to any network management system (NMS) in the network, including the primary
server (S8300, S8500, or S8700). The MGP CLI
NMS network element that will receive those traps.
The command syntax is:
set SNMP trap <IP address> {enable|disable}
[{all|power|temp|app|module|config|voice|operations}]
where
<IP address>
from the G700, and
[{all|power|temp|app|module|config|voice|operations}]
be sent to the specified receiver. If no keywords follow the IP address entry, then 'all' traps will be
enabled for the specified receiver.
If 'enable' or 'disable' is used without a trap designation keyword, then 'all' traps is assumed. Up
to ten trap receivers can be configured.
1
At the P330-1(super)# prompt, type
2
At the mg-xxx-n(super-user)# prompt, type
3
At the mg-xxx-n(configure)# prompt,
type set snmp trap <IP address> enable
4
Type
exit
Installation and Upgrades for G700 and S8300
December 2003
set snmp community trap [community string]
root .
set snmp community trap [community string]
is the IP address of the NMS trap receiver that will be receiving the traps
session mgp
Installing a New G700 with an S8300
Set Up SNMP Alarming on the G700
set snmp trap <IP address> enable
.
command is the way to configure the
set snmp trap
indicates the groups whose traps will
and press
configure Enter
and press Enter .
and press
.
167
3