Get Ia770 (Audix) Data And Stop Ia770; (If Ia770 Is Being Used); Back Up Recovery System Files; Back Up Data - Avaya G700 Installation And Upgrades

5
Upgrading an Existing G700 with an S8300 — R1.x to R2.0
On-site Preparation for the Upgrade

Get IA770 (AUDIX) Data and Stop IA770

(if IA770 is being used)

Skip to

Back up recovery system files

If IA770 is being used, you need to collect some data, leave a test message, and shut down IA770 before
backing up the files.
1
To test IA770 after the migration, write down the number of a test voice mailbox, or create one if
none exists. Also write down the number of the IA770 hunt group.
2
Leave a message on the test mailbox that will be retrieved after the migration.
3
Click Start > Run to open the Run dialog box.
4
Type
5
Log in as craft or dadmin.
6
Type
The shutdown will take a few minutes.
7
Type
When the shutdown is complete, you will see only the voicemail and audit processes. For
example:
voicemail:(10)
audit http:(9)
Press Ctrl+C to break out of the
8
Type
shut down, you will see "voice system is down."
NOTE:
After the S8300 upgrade, you must upgrade the G700 and media module firmware before
restarting IA770.

Back up recovery system files

Before installing the S8300 upgrade software, you should back up the system data in case there's a need
to back out of the upgrade. To do this, you need an FTP address, directory path, and a user ID and
password to access an FTP server on the customer's network. Check with your project manager or the
customer for this information.

Back up data

1
Under Data Backup/Restore, click Backup Now.
224
on page 224 if IA770 is not being used.
telnet 192.11.13.6 and press Enter.
stop -s Audix and press Enter to shut down AUDIX.
watch /VM/bin/ss and press Enter to monitor the shutdown.
watch
/vs/bin/util/vs_status and press Enter to verify that AUDIX is shut down. When AUDIX is
CAUTION:
If the current release is 1.1.x, you must backup the Communication Manager translations
(and AUDIX data if IA770 is installed) using this procedure.
command.
Installation and Upgrades for G700 and S8300
December 2003