Epson SureColor F9200 User Manual page 80

Options
Head Alignment
Heating & Drying
Media Suction
Head Movement
Multi-Strike Printing
Roll Type
Description
Select one of the following when print results are grainy or
out of focus:
Manual(Bi-D): when printing in both directions.
Manual(Dual Head): if the previous setting does not
improve the results, or if you are printing in one direction.
Manual(Uni-D): if the previous setting does not improve
the results.
Set any of the following:
Heater Temperature: from 86 to 131 °F (30 to 55 °C);
defaults to 122 °F (50 °C).
Drying Time Per Pass: from 0.0 to 10.0 seconds. You can
maintain a constant drying time by basing it on the media
width.
After Heater Feed: feeds media to the after heater after
printing (if the media will be cut before the next job starts).
Blank Area Feed: speeds up feeding of blank areas, from
Mode 0 (highest speed) to Mode 3.
Set from 0 to 10 to increase the gap between the print head
and thin or flexible media. If print quality is reduced or
media does not feed correctly, you may need to lower the
suction.
Selects the range of print head movement:
Data Width: increases print speed by restricting movement
to the printed area.
Printer Full Width: provides more even print results.
Select the number of times each line is printed, from 2 to 8
(or select Off to disable).
Select Printable Side Out or Printable Side In based on
how the media is rolled.
80