• If you printed thin media or media lengthened by water absorption, vertical creases that look like this
may occur between the pressure rollers:
Do the following to reduce creasing:
• Set the Feeding Tension setting to Manual and increase the tension values.
• Set the Take-up Tension setting to Manual and decrease the tension values.
• Attach a spacer in the slot of the media loading lever.
Parent topic:
Related references
Media Setup Menu Settings
Printing Continues After Media Roll Empties
If printing does not stop when the media roll ends, make sure the Media End Check setting is set to On.
For best results, leave this setting turned on.
Parent topic:
Related references
Printer Setup Menu Settings
Solving Printing Problems
Solving Printing Problems
185