Table of Contents
Advertisement
4
Right margin
You select this margin as the total of the values for the Print Start Position (default setting is 0)
and Side Margin(Right) (default setting is 0.2 inch [5 mm]) settings on the product control panel.
You can select from 0.12 inch (3 mm) to 32.5 inches (825 mm).
5
Media width
11.8 to 64 inches (300 mm to 1626 mm); if Media Size Check is off, the product assumes this is
64 inches (1626 mm) regardless of the actual width
1
The configured margin and the actual print results may differ depending on the RIP software you use.
Contact the RIP manufacturer for more information.
2
When you set the Margin Between Pages setting to the No Margin option on the product control
panel, you can adjust the margin from –0.39 inch (–10 mm) to 0.39 inch (10 mm).
3
Depending on the RIP software, you may be able to use it to set these margins. Contact the RIP
manufacturer for more information.
4
When using the media holding plates, leave margins of at least 0.4 inch (10 mm) to avoid printing over
the plates. If the total of the print data width and left and right margins exceeds the printable area, a
portion of the print data will not print.
Parent topic:
Related references
Printer Setup Menu Settings
Printing the Amount of Media Remaining
After you print, you can print the amount of media remaining on the leading edge of the remaining roll.
This lets you enter the number the next time you load the media for the most accurate accounting of the
media remaining on each roll
Note: You must have turned on the Remaining Setup setting on the product control panel to calculate
the amount of media remaining.
1. Make sure your product is ready to print.
2. Press the
press the OK button.
3. Select the Print Remaining Length setting and press the OK button.
4. Press the OK button to print the amount of media remaining.
3
4
,
Media Handling
media setup button, select the Media Remaining setting in the displayed menu, and
45
Advertisement
Table of Contents
