T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Command Mode
Interface Configuration Mode
Example
Configure the LSA transmission delay of interface VLAN 2 as 2 seconds.
T2700G-28TQ(config)# interface vlan 2
T2700G-28TQ(config-if)# ip ospf retransmit-delay 2
ip ospf priority
Description
The ip ospf priority is used to configure the priority of the specified interface.
To restore to the default value, please use the no ip ospf priority command.
Syntax
ip ospf priority pri
no ip ospf priority
Parameter
pri —— The priority of the interface, ranging from 0 to 255 and the default value
is 1. Interface with the priority 0 cannot be elected as DR or BDR.
Command Mode
Interface Configuration Mode
Example
Configure the priority of the interface VLAN 2 as 1:
T2700G-28TQ(config-if)# ip ospf priority 1
ip ospf hello-interval
Description
The ip ospf hello-interval is used to configure the hello intervals on the
specified interface. To restore to the default value, please use the no ip ospf
hello-interval command.
388