Table of Contents
Advertisement
T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
cost—— The cost of the aggregated route, ranging from 1 to 16777214. The
default value is the maximum one of all the aggregated routes.
Command Mode
Router Configuration Mode
Example
Configure one aggregated route 100.100.0.0/16 with the cost 10 in the Area 0:
T2700G-28TQ(config)# router ospf 1
T2700G-28TQ(config-router)# area 0 range 100.100.0.0 255.255.0.0 cost 10
area virtual-link
Description
The area virtual-link command is used to configure the virtual-link. To delete
the configured virtual-link, please use the no area virtual-link without any
optional parameters. To restore the certain parameters to default values, please
use the no area virtual-link command with corresponding parameters.
Syntax
area transit-area virtual-link router-id [ dead-interval dead-interval ]
[
hello-interval
[ transmit-delay trans-delay ]
no area transit-area virtual-link router-id [ dead-interval dead-interval ]
[
hello-interval
[ transmit-delay trans-delay ]
Parameter
transit-area —— The transition area ID in the format of an IP address in dotted
decimal notation or decimal value ranging from 0 to 4294967295.
router-id —— The ID of the neighboring router on the opposite end of the virtual
link, in the format of dotted decimal notation.
hello-interval —— The interval of the hello packets, ranging from 1 to 65535
seconds and the default value is 10 seconds.
dead-interval —— The time after which the neighbor becomes invalid. It ranges
from 1 to 65535 seconds and the default value is 4 times as the hello-interval.
hello-interval
]
[
hello-interval
]
[
381
retransmit-interval
retransmit-interval
rtx-interval
]
rtx-interval
]
Advertisement
Table of Contents
