Table of Contents
Advertisement
T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Example
Configure the authentication mode of a virtual-link as simple authentication, with
the transmission area as Area 2 and the ID of the neighboring router on the
other endpoint as 3.3.3.3, and the authentication key as 123456:
T2700G-28TQ(config)# router ospf 1
T2700G-28TQ(config-router)# area 2 virtual-link 3.3.3.3 authentication-key
123456
area virtual-link message-digest-key
Description
The area virtual-link message-digest-key is used to configure the MD5
authentication ID and key of the virtual-link. To delete the specified configuration,
please use the no area virtual-link message-digest- key command.
Syntax
area transit-area virtual-link router-id message-digest-key id md5 { [ 0 ]
password | 7 encrypted-password }
no area transit-area virtual-link router-id message-digest-key id
Parameter
transit-area —— The transition area ID, in the format of an IP address in dotted
decimal notation or decimal value ranging from 0 to 4294967295.
router-id —— The ID of the neighboring router on the other endpoint of the
virtual link, in the format of dotted decimal notation.
id—— The key ID of the MD5, ranging from 1 to 255.
0 —— Specify the encryption type. 0 indicates that an unencrypted password
will follow. By default, the encryption type is 0.
password —— Super password, a string from 1 to 16 alphanumeric characters
or symbols. The password is case sensitive, allows spaces but ignores leading
spaces, and cannot contain question marks. By default, it is empty.
7 —— Indicates a symmetric encrypted password with a fixed length will follow.
encrypted-password —— A symmetric encrypted password with a fixed length,
which you can copy from another switch configuration. After the encrypted
password is configured, you should use the corresponding unencrypted
password if you re-enter this mode.
385
Advertisement
Table of Contents
