Table of Contents
Advertisement
T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Mode
Accessing Path
Layer 2 Interface:
Use
gigabitEthernet
interface
gigabitEthernet
command to enter this mode
from
mode.
Interface
Layer 3 Interface:
Configuration
Use
Mode
command to enter Routed Port
mode
Configuration mode.
Use the interface vlan vlan-id
command
Interface mode from Global
Configuration mode.
Use the interface loopback id
command to enter Loopback
Interface mode from Global
Configuration mode.
Use the ip dhcp server pool
DHCP
pool-name command to enter
Configuration
DHCP
from
Mode
mode.
Use the spanning-tree mst
MST
configuration
Configuration
enter this mode from Global
Mode
Configuration mode.
Note:
1.
The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a console port or by a telnet connection.
2.
Each command mode has its own set of specific commands. To configure some commands,
you should access the corresponding command mode firstly.
Global Configuration Mode: In this mode, global commands are provided, such as the
Spanning Tree, Schedule Mode and so on.
the
interface
port
or
range
port-list
Global
Configuration
no
switchport
the
from
Interface
to
enter
VLAN
T2700G-28TQ(config-if-
range)#
Configuration
Mode
T2700-28TQ(config-dhcp)
Global
Configuration
command
to
T2700G-28TQ(config- mst)#
Prompt
T2700G-28TQ(config-if)#
T2700G-28TQ(config-if- range)#
T2700G-28TQ(config-if)#
20
Logout or Access the
next mode
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.
A port number must be
specified in the interface
command.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command
to
return
to
Global
Configuration
mode.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command
to
return
to
Global
Configuration
mode.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command
to
return
to
Global configuration mode.
Advertisement
Table of Contents
