T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Parameter
area-id —— The area ID, in the format of an IP address in dotted decimal
notation or decimal value ranging from 0 to 4294967295.
descript—— The area name, ranging from 1 to 20 characters.
Command Mode
Router Configuration Mode
Example
Configure the name of area 0 as SOFT:
T2700G-28TQ(config)# router ospf 1
T2700G-28TQ(config-router)# area 0 description SOFT
area authentication
Description
The area authentication command is used to configure the authentication
mode of the specified area. Interfaces in this area will be authorized using the
area's authentication mode if their authentication modes are not configured
manually. To restore to the default setting, please use the no area
authentication command. It is not authorized by default.
Syntax
area area-id authentication [ message-digest ]
no area area-id authentication
Parameter
area-id —— The area ID, in the format of an IP address in dotted decimal
notation or decimal value ranging from 0 to 4294967295.
message-digest —— MD5 authentication. If this parameter is missing, a simple
authentication will be applied.
Command Mode
Router Configuration Mode
377