Toshiba PORTÉGÉ M700 Maintenance Manual page 334

4 Replacement Procedures
Installing the Switch board/Fingerprint sensor board
The following describes the procedure for installing the switch board/fingerprint sensor board.
(See Figure 4-55.)
1. Connect the fingerprint sensor cable to the connector on the back of the fingerprint
sensor board.
2. Set the fingerprint sensor board in place and secure it with the following screw.
• M2.5×4.0B
3. Connect the switch cable to the connector on the back of the switch board.
4. Set the switch board in place and secure it with the following screw.
• M2.5×4.0B
4-106 [CONFIDENTIAL]
4.33 Switch board/Fingerprint sensor board
FLAT HEAD screw
FLAT HEAD screw
PORTÉGÉ M700 Maintenance Manual (960-661)
×1
×1