Setting Up Schedules - GE NX-10 Installation Manual

7 Any siren
8 Zone bypass
9 AC failure
10 System low battery
11** Duress
12** Manual fire
13** Manual medical alarm
14** Keypad panic
15 Keypad tamper (wrong
codes)
16** Automatic test
17 Alarm memory
18 Entry
19 Exit
20 Entry or exit
See Schedule Times>Opening and Schedule Times>Closing/Autoarm
*
If set to follow condition, these events are one second
**
Events 48, 49 and 50 arm or disarm the NX-10 at the open (disarm) or close (arm) time for the
♠
appropriate schedule.
Note: For events 48 and 50, the keypad buzzer will sound one minute prior to auto arm if the zone value is 1.
If the zone value is 0, the keypad will not sound prior to auto arm.

Setting up schedules

You can set up a schedule to control the day and time at which the system automatically opens and
closes or the days on which specific output events are active. You can also specify certain days on
which the schedule is not active. For example, you might use a schedule to disarm the system each
morning at a certain time. However, on holidays you might not want the system to disarm at this
time. The following example sets up January 1st as the day on which schedule 1 is not active.
Navigate with the
1.
Scroll to Schedule 1>Active>Disable on Holidays>Yes and press OK.
2.
Navigate with the
3.
The keypad beeps once to accept the change and returns to Day 1.
4.
To use this schedule, enable Outputs>Schedules for the selected output. For information
5.
on how to enable this option, see Configuring an output.
28** Expander trouble
29 Dynamic battery
test
30** Open schedule
31** Closed schedule
32 Listen in
33 Line seizure
34 Failed to
communicate
35 Telephone line fault
36 Program mode
37 Download
38 Follow zone status in
alarm
39 Over current (12
Vdc)
40 Box tamper
41 Siren tamper
keys to NX-507/508E>Output Exp 24>Schedules and press OK.
keys to Date of holidays>January>Day 1>1 and press OK.
49♠
50♠
51
52
53
54
55
56
57
58
59
60
61
62
.
Auto disarm control
Auto arm & disarm control
Follow schedule of NX-508E
Flash X-10 for alarm
memory
Flash X-10 for siren
Armed in 'Exit' mode, after
exit time
End listen-in
Compare X-10 commands
with X-10 addresses
(activate exit by means of
DTMF commands)
Disarmed : state of zone
Armed : latch
Service required
Armed in "STAY" mode
Sensor low battery
Sensor missing (lost)
B-alarm