GE NX-10 Installation Manual page 35

LOC PG DESCRIPTION
243 27 PROGRAMMING THE ZONES
Seg
1
Seg
2
244 27 READER TIMES
Seg
1
Seg
2
Seg
3
Seg
4
245 28 RESET THE READER ADDRESS
CAUTION: Entering a "0" will
reset and cause the reader to cease
functioning.
246 28 PROGRAMMING THE ACCESS OPTIONS
Seg
1
Seg
2
Seg
3
Door Shunt Zone
Request to Exit (RTE)
Scan Time (1/100 seconds)
Relay Active Time (seconds)
Door Fault Warning Time
(seconds)
Door Fault Alarm Time
(seconds)
DOOR OPTIONS
"On" if locking mechanism is a Maglock or Drop Bolt.
"On" if access is allowed regardless of Armed status of the system.
"On" if the door is not to be latched unlocked during an open schedule.
"On" if onboard open collector output only triggers during an open schedule.
"On" if onboard open collector output only triggers during a close schedule.
"On" if Forced Entry Alarm is logged.
"On" if access allowed without an RTE.
"On" if relay operates normally during off-schedule
SCHEDULES FOR ONBOARD OPEN COLLECTOR OUTPUT
"On" if driver follows Schedule 1.
"On" if driver follows Schedule 2.
"On" if driver follows Schedule 3.
"On" if driver follows Schedule 4.
"On" if driver follows Schedule 5.
"On" if driver follows Schedule 6.
"On" if driver follows Schedule 7.
"On" if driver follows Schedule 8.
MORE DOOR OPTIONS
NX-10 Expander Installation Guide
DEFAULT
0 = Disabled
0 = Disabled
100 = 1 second
10 = 10 seconds
30 = 30 seconds
0 = 0 seconds
35
YOUR DATA