Programming The Locations For Nx-507E/Nx-508E - GE NX-10 Installation Manual

Location Term
9.1.4 Users
9.1.4.1.1 Outputs
9.1.5 Model
9.1.6 Version
9.1.7 Reset Settings

Programming the locations for NX-507E/NX-508E

LOCATION 0 - PROGRAMMING THE EVENT, USER/ZONE AND TIME FOR OUTPUT 1 (3 segments,
numerical data)
Segment 1 - Event
Selects the event that will trigger the output. See chart below for the specific events that can be
selected.
Segment 2 - Zone/user
Selects the zone or user number necessary to trigger an output. If this location is programmed as a
zero ("0"), any zone or user will activate the output (see also location 68).
Segment 3 - Time
Selects the amount of time an output will remain activated when an output triggers. If this location is
programmed as a zero, the output will follow the particular event.
Nr. Event
0** Burglary alarm
1** Fire alarm
2** 24 hour alarm
3** Zone trouble (fire/day)
4** Zone tamper
5 Burglary siren
6 Fire siren
7 Any siren
8 Zone bypass
9 AC failure
Definition
A menu option that specifies the zone or user number that
triggers the output on the expander module or power
module.
A menu option that specifies which outputs the selected
user can operate. The users menu can be used only when
event 45 (code entry) is used.
A menu option that displays the current model of the
selected output expander.
A menu option that displays the current software version of
the selected output expander.
A menu option that defaults the selected output expander.
Nr. Event
21 Armed
22 Not armed
23 Ready
24 Not ready
25 Fire
26 Fire trouble
27 Chime
28** Expander trouble
29 Dynamic battery
test
30** Open schedule
Nr. Event
42 Any zone faulted
43** Any alarm
44 Keypad beeping
45** Code entry
46♦ Key FOB function 1
47♦ Key FOB function 2
48♠ Auto arm control
49♠ Auto disarm control
50♠ Auto arm & disarm control
51 Follow schedule of NX-508E