GE NX-10 Installation Manual page 85

Location Term
9.1.1.1.6.2 Code Stops Timer
9.1.1.1.6.3 Only if Closed
9.1.1.1.6.4 Only if Open
9.1.1.1.6.5 Inverted
9.1.1.1.6.6 Log Event
9.1.1.1.7 Schedules
9.1.1.1.8 X-10 Address
9.1.1.1.8.1 Unit Code
9.1.1.1.8.2 House Code
9.1.2 Schedules
9.1.2.1.1 Opening
9.1.2.1.2 Closing
9.1.2.1.3 Active
9.1.2.1.3.2 Disable on Holidays
9.1.3 Date of holidays
Definition
A menu option that allows the timer used on
programmable outputs to be reset by entering a valid user
code.
A menu option that activates an output after closing time
and before opening time. During these times, codes can be
used to arm/disarm the system. A timer is used to set these
times.
A menu option that activates an output between opening
time and closing time.
A menu option that enables a mode that inverts the state
of an output (normally activated and then deactivated
when an event occurs).
A menu option that causes the selected output to log an
event when it is activated.
A menu option that selects the schedules that affect the
selected output.
A menu option that sets the address of an X-10 device. This
is a unique number assigned to an X-10 device. It consists
of the module number and house code. The system uses
this address to identify the device.
A menu option that sets the X-10 module number used to
identify a particular X-10 device on the selected module.
A NetworX bus module number is assigned to each system
module. The system uses this number to identify the
module. It is also used to report module problems (such as
tampers and module supervision lost) to the central station.
A menu option that sets the code used to identify a
particular premises. It is necessary in case any
neighbouring premises also has an X-10 home automation
system.
More information on the X-10 home automation system
can be found at www.x-10europe.com.
A menu entry that groups scheduling options. These
options set the times to start and end an operation.
A menu option that sets the time at which the selected
schedule enters the open state.
A menu option sets the time at which the selected
schedule enters the closed state.
A menu option that specifies the days of the week that a
particular schedule is active.
A menu option that activates the holidays feature. The
selected schedule is not active on the dates specified in
Date of holidays.
A menu option that sets the dates of holidays. If the
holidays feature (7.1.2.1.3.2) has been enabled, no
schedules are active on these dates. Up to eight holidays
per month can be specified.
NX-10 Expander Installation Guide
85