GE NX-10 Installation Manual page 89

LOCATIONS 4-31 - PROGRAMMING FOR OUTPUTS 2 - 8
Locations 4 - 31 are used to program the events, zones/users and times, as well as the special
functions, partitions, schedules and X-10 addresses for outputs 2 - 8. Each output has four locations,
which are programmed with the same steps, as output 1 described previously. Refer to output 1 for
specific instructions (locations 0 - 3). Also refer to the programming worksheets.
LOCATION 32 - PROGRAMMING THE OPENING TIME FOR SCHEDULE 1 (2 segments, numerical
data)
Segment 1 Program the hour of the opening time in 24 hour format (1:00 PM = 13)
Segment 2 Program the minutes after the hour of the opening time for schedule 1
LOCATION 33 - PROGRAMMING THE CLOSING TIME FOR SCHEDULE 1 (2 segments, numerical
data)
Segment 1 Program the hour of the closing time in 24 hour format (1:00 PM = 13)
Segment 2 Program the minutes after the hour of the closing time for schedule 1
LOCATION 34 - PROGRAMMING THE DAYS FOR SCHEDULE 1 (1 segment, feature selection
data)
Option Function
1 ON If the schedule is active on Sunday
2 ON If the schedule is active on Monday
3 ON If the schedule is active on Tuesday
4 ON If the schedule is active on Wednesday
5 ON If the schedule is active on Thursday
6 ON If the schedule is active on Friday
7 ON If the schedule is active on Saturday
8 ON If the schedule is disabled on Holidays
LOCATIONS 35-55 - PROGRAMMING FOR SCHEDULES 2 - 8
Locations 35 - 55 are used to program the opening times, closing times, and days for schedules 2 - 8.
Each schedule has three locations, which are programmed with the same steps, as schedule 1
described previously. Refer to schedule 1 for specific instructions (locations 32 - 34). Also refer to
the programming worksheets.
NX-10 Expander Installation Guide
89