Configuring Tcp/Ip Reporting; Configuring Email Reporting - GE NX-10 Installation Manual

You must enrol and default the module before you begin to program the system. You can program
the NX-590E TCP/IP module using a keypad or DL900 software. To program the NX-590E using a
keypad, select Installer Menu>NX-590E.

Configuring TCP/IP reporting

The NX-590E TCP/IP module can report to two receivers. You can configure the events to be
reported, the reporting format and the reporting connection parameters. The following example uses
TCP/IP reporting to send primary reports for tamper events occurring in partition 1 to receiver 1 (IP
address 122.168.1.1).
Navigate with the
1.
Scroll to IP Address and press OK.
2.
Enter 122.168.1.1 and press OK.
3.
The keypad beeps once to confirm the change and returns to IP Address.
4.
Scroll to Events>Tamper/Fault>Tampers and press OK.
5.
Press the relevant keys to include partition 1 in the tamper and restores event report.
6.
The keypad beeps once to accept the change and returns to Tampers.
7.
Navigate with the
8.
relevant for your central station receiver.
Obtain the IP port and IP address, gateway and subnet mask for the NX-590E TCP/IP
9.
module:
•
For Windows 9X / Windows ME, type ipconfig at the DOS prompt.
•
For Windows 2000 / XP, type ipconfig at the COMMAND prompt.
Navigate with the
10.
Scroll in turn to Our IP Address, Gateway IP Address, Subnet Mask and Port Numbers
11.
and enter the information obtained in step 9.

Configuring email reporting

Reporting to email addresses can include computers, cell phones, pagers and devices. You can
configure the events to be reported, the reporting format and the reporting connection parameters.
When using email reporting, you must configure the server settings and the NX-590E email address
and port. The following example uses email reporting to send primary reports for alarms occurring on
in partition 2 from ouremail@myemail.com to email address 1 (user1@myemail.com).
Navigate with the
1.
press OK.
Enter ouremail@myemail.com and press OK.
2.
The keypad beeps once to confirm the change and returns to Our E-mail Address.
3.
Scroll to E-mail Accounts>E-mail 1>E-mail Address and press OK.
4.
Enter user1@myemail.com and press OK.
5.
The keypad beeps once to confirm the change and returns to E-mail Address.
6.
Scroll to Events>Arm/Disarm/Alarm>Alarms and press OK.
7.
keys to NX-590E>TCP/IP Reporting>Receiver (1) and press OK.
keys to Options>Reporting>Report Format and select the format
keys to Network and press OK.
keys to NX-590E>E-mail Reporting>Our E-mail Address and
NX-10 Expander Installation Guide
139