GE NX-10 Installation Manual page 91

91
NX-10 Expander Installation Guide
activating certain outputs. Location 69 contains 10 segments. Segment 1 corresponds to user 11,
segment 10 corresponds to user 20. Refer to location 68 chart.
Note: The zone/user for the corresponding output must be "0" to use this location.
LOCATION 70 - AUTHORIZING USERS 21 - 30 TO TRIGGER OUTPUTS 1 - 8 (10 segments, feature
selection data)
When activating outputs with a user code, location 70 can be used to restrict certain codes from
activating certain outputs. Location 70 contains 10 segments. Segment 1 corresponds to user 21,
segment 10 corresponds to user 30. Refer to location 68 chart.
Note: The zone/user for the corresponding output must be "0" to use this location.
LOCATION 71 - AUTHORIZING USERS 31 - 40 TO TRIGGER OUTPUTS 1 - 8 (10 segments, feature
selection data)
When activating outputs with a user code, location 71 can be used to restrict certain codes from
activating certain outputs. Location 71 contains 10 segments. Segment 1 corresponds to user 31,
segment 10 corresponds to user 40. Refer to location 68 chart.
Note: The zone/user for the corresponding output must be "0" to use this location.
LOCATION 72 - AUTHORIZING USERS 41 - 50 TO TRIGGER OUTPUTS 1 - 8 (10 segments, feature
selection data)
When activating outputs with a user code, location 72 can be used to restrict certain codes from
activating certain outputs. Location 72 contains 10 segments. Segment 1 corresponds to user 41,
segment 10 corresponds to user 50. Refer to location 68 chart.
Note: The zone/user for the corresponding output must be "0" to use this location.
LOCATION 73 - AUTHORIZING USERS 51 - 60 TO TRIGGER OUTPUTS 1 - 8 (10 segments, feature
selection data)
When activating outputs with a user code, location 73 can be used to restrict certain codes from
activating certain outputs. Location 73 contains 10 segments. Segment 1 corresponds to user 51,
segment 10 corresponds to user 60. Refer to location 68 chart.
Note: The zone/user for the corresponding output must be "0" to use this location.