GE NX-10 Installation Manual page 12

For general information about navigating menus, and entering or selecting values, see Chapter 1
Programming guidelines on page 8. For general information about location-based programming, see
Guidelines for location-based programming on page 10.
The basic menu structure is as follows:
Figure 1. Installer menu overview
OK=LOC =MENU
1.
Control Panel
2.
This Keypad
3.
Other keypads
4.
RF Receivers
5.
NX-1701 Proximity Readers
6.
NX-1750 Proxpad
7.
NX-216 Input Expanders
8.
NX-320 Power Modules
9.
NX-50x Output Expanders
1 . 0
NX-534 Listen-in Module
1 . 1
NX-535 Voice Module
1 . 2
NX-584 Home Automation
1 . 3
NX-586 Direct Connect
1 . 4
NX-590E TCP/IP
1 . 5
NX-7002 GPRS Module
1 . 6
NX-910x VVM
1 . 7
Enrol Modules
1 . 8
Maintenance Mode
1 . 9
Note: All the menu diagrams in this manual comply with the menu order and numbering used in the NX-10 Menu
Diagram and described in Figure 1.
For information about programming the control panel, keypads, RF receivers and GPRS module, see
the NX-10 Installers Manual.