Secondary (Pulley) Axle Set Replacement - Vision Fitness R70 Service Manual

CHAPTeR 7: PART RePlACeMeNT GUiDe
7.12 SeCoNDARy (PUlley) Axle RePlACeMeNT
1) remove both front side covers as outlined in Section 7.7.
2) remove the generator belt as outlined in Section 7.11.
3) remove the screw holding the small clutch pulley in place and remove the clutch pulley (Figures A & B).
fiGURe A fiGURe b
4) Use a large crescent wrench or channel lock pliers to remove the secondary axle nut (Figure C).
5) Use a hammer or mallet to remove the secondary axle set from the frame (Figure D).
fiGURe C fiGURe D
6) reverse Steps 1-5 to install a new secondary axle set. NOTE: If a hammer or mallet is needed to install the new secondary axle bearings
into the frame, be sure to protect the secondary axle so that it is not damaged by the hammer or mallet.
7) test the bike for function as outlined in Section 7.23.
39