7.11 GeNeRAToR / eCb belT RePlACeMeNT
1) remove both front side covers as outlined in Section 7.7.
2) walk the generator belt off of the secondary axle pulley (Figure A).
3) loosen the large eye hook nut on the generator (Figure B).
fiGURe A
4) remove the small eye hook nut on the generator (Figure C).
5) repeat Steps 3-4 on the opposite side.
6) remove the screw keeping the generator disc from spinning (Figure D).
fiGURe C
CHAPTeR 7: PART RePlACeMeNT GUiDe
fiGURe b
fiGURe D
37