Secure Protocols; Ipv6 Settings - Oce PlotWave 750 Operation Manual

Secure protocols

Secure protocols

IPv6 settings

Introduction
In case IPv6 is enabled:
• You can see all IPv6 information in the [Configuration] - [Overview] tab
• If IPv6 is enabled, the System Administrator or Power User can change some of the IPv6
settings.[Connectivity]
IPv6 settings
The following settings are available for IPv6:
[IPv6 Link Local address]:
[IPv6 Stateless (SLAAC) address]:
[Enable IPv6 address configuration by DHCP]
[IPv6 manual address]:
[IPv6 Gateway by DHCP]:
[IPv6 default gateway address].
[Enable IPv6 DNS configuration by DHCP]:
[IPv6 address of DNS server].
108 Chapter 3 - Define your workflow with Océ Express WebTools
This address is determined automatically. you
cannot change them.
This address is determined automatically. you
cannot change them.
The IPv6 DNS address can be provided by the
DHCP server when a DHCP server is available.
If not, enter the address manually.
the IPv6 address when set manually. Enter the
value "::" or "0:0:0:0:0:0:0:0" to disable a man-
ual IPv6 address.
It is recommended not to check it. Enter the
Gateway address manually.
Fill it in to set the IPv6 default Gateway ad-
dress.
The IPv6 DNS address can be provided by the
DHCP server when a DHCP server is available.
It is automatically set when the DHCP server is
available and enabled. If the DHCP server is
not enabled, the IPv6 address of the DNS serv-
er can be set manually. Then enter the IPv6 ad-
dress of the DNS server manually.