Offline Folding - Oce PlotWave 750 Operation Manual

Offline folding

Offline folding
Introduction
An important feature provided by the folder is offline folding. You can use the same settings for
offline folding and normal folding. Define the default settings for offline folding on the printer
operator panel (in Offline mode). Do not fold polyester or transparent media. This media can
cause media jams.
Offline folding settings
Output selection
"Stacker" or
"Belt"
"Stacker" or
"Belt"
"Stacker" or
"Belt"
"Stacker" or
"Belt"
"Stacker" or
"Belt"
NOTE
Use offline folding only for the sheets that do not exceed a maximum length of 6 m. If you try to
fold a sheet longer than 6 m, an error occurs.
Procedure
1.
Press the [On-line key] key on the printer operator panel and watch the light on the top cover of
the folder.
Indication light folder
If
the light is off
the light blinks slowly
the light blinks rapidly
the light is on
NOTE
See the label on the top cover of the folder.
2.
Make any setting for (offline) folding on the printer operator panel.
3.
Feed the sheet of paper face down and with the legend on your right-hand side.
NOTE
Wait until the light on the folder no longer blinks before you feed a new sheet. A media jam can
occur.
4. Collect your output.
214 Chapter 6 - The finishing options
Output length
=< 2 m
2 m - 2.5 m (2 folds)
2 m - 2.5 m (3 folds)
> 2.5 m
< 6 m
Then
the printer is online and offline folding is not possible.
the printer is offline but the folder is still processing the last
prints.
an error has occurred
the printer is offline and you can feed a sheet.
Delivery
Delivered on stacker or belt
Delivered on stacker or belt
Stopped in second fold (possible pa-
per jam)
Unfolded, delivered in the top deliv-
ery tray
First fold only, delivered in first fold
delivery