Configure The Sleep Mode Timer - Oce PlotWave 750 Operation Manual

Configure the sleep mode timer

Configure the sleep mode timer
Introduction
If the printer is idle for a defined period it goes into sleep mode. In sleep mode, the printer uses
minimal energy. The power supply of the controller remains on.
The printer enters the sleep mode when the sleep mode timer expires.
You cannot disable sleep mode, but you can adjust the value of the sleep mode timer. The default
value is 30 minutes. The range is 5 - 240 minutes.
Procedure
1.
Click [Preferences] - [System settings].
2.
Click [Edit] in the 'System properties' bar or click the value of the [Sleep mode timeout] setting.
3.
Enter a new value in the Edit window and click [Ok] to confirm your entries or [Cancel] to reject
your entries.
NOTE
If you access the Edit window by clicking the value of the setting you want to change, the Edit
window displays the minimal and maximal value you can select.
NOTE
When the printer is in sleep mode, there are several ways to activate the system.
• send a print job.
• press a button on the operating panel of the printer.
• press a button on the operating panel of the scanner.
74 Chapter 3 - Define your workflow with Océ Express WebTools