Table of Contents
Advertisement
Adjustment
3.5
05 Density Unevenness Adjustment
Adjust the density unevenness of printed images in crosswise direction to the paper feed direction.
0
The Automatic Gamma Adjustment (page 3-18, page 6-44) should be performed in advance.
0
This adjustment will be required afresh when the screen type selection has been changed. As the
density unevenness may vary according to machine conditions, occasionally check whether the current
adjustment value is appropriate or not.
1
Touch [Adjustment] on the Machine Status Screen.
The Adjustment Menu Screen will be displayed.
2
Touch [05 Density Unevenness Adj.].
The Density Unevenness Adjustment Setting Screen will be displayed.
3
Touch [COPY] tab.
The Copy Screen will be displayed.
4
Select the screen type to be adjusted (which shows the density unevenness), then press [Start].
The test patterns will be output.
5
Touch the [ADJUSTMENT] tab to return to the Density Unevenness Adjustment Setting Screen.
6
Touch the color (Y, M, C, K) and point (0 to 8) keys to be adjusted.
7
Use the touch panel keypad to enter the desired adjustment value, then touch [<<SET].
Available range: -32 to +31 (-: thin, +: deep)
–
Touching [+]/[,] increases/decreases the adjustment value, and the control panel keypad can also
be used to enter the value.
–
Touch [Y (or M/C/K) Clear] to clear all the adjustment values of that color.
8
Touch [Invalid] of the color to be adjusted to change it to [Effect].
CS655 Pro
3
3-37
Advertisement
Table of Contents
