Pre-Event; Event Setup; Alarm-In; Figure 42 - Pre-Event Setup Screen - Eneo DLR-2016/500V Operating Instructions Manual

User's Manual
Highlighting boxes under Resolution and pressing the
for Time and Event recording. You can select from: Very High (D1), High (Half D1) and Standard (CIF).
Highlighting boxes under Dwell and pressing the
record for the associated event. (Advanced Mode Only)

Pre-Event

Highlight Pre-Event in the Record menu and press the
do not have Event set up in the Record Schedule, a message will display alerting you to this fact.
Figure 42 — Pre-Event setup screen.
NOTE: When the DVR is in the Time or Time & Event mode, it ignores the pre-event settings and follows the
time settings.

Event Setup

Alarm-In

Highlight Alarm-In in the Event menu and press the
36
button allows you to set the recorded image resolution
button allows you to set the length of time you would like to
button, and the Pre-Event setup screen appears. If you
When the DVR is in the Event Record mode it is possible to
have it record images before the event occurs. The Pre-Event
screen allows you to define how to handle pre-event recording.
You can turn individual cameras On or Off for pre-event
recording. The image speed can be set from 1.00 to 30.00 ips
(25.00 ips PAL), image quality can be selectable from Very
High, High, Standard and Basic, and image resolution can
be selectable from Very High (D1), High (Half D1) and
Standard (CIF).
You can set the amount of time to record prior to the event
by adjusting the Dwell. You can set the Dwell from 5 seconds
to 30 minutes. The longer the dwell set, the fewer maximum
ips can be set.
Figure 43 — Event menu.
button. The Alarm-In setup screen appears.