Video Loss; Figure 47 - Motion Detection Actions Screen - Eneo DLR-2016/500V Operating Instructions Manual

NOTE: The record action for motion events will not be affected by the Motion Ignoring function.
Highlighting Daytime Setup and pressing the
Highlight the Actions tab, and the Motion Detection Actions setup screen appears.
Figure 47 — Motion Detection Actions screen.
NOTE: For the Record action, the camera you select should be set to the Event or Time & Event recording mode
in the Record Schedule setup screen.
Highlight the box under the Alarm-Out heading and press the
associate as many Alarm-Outs with that camera as you wish. When the DVR detects motion on the selected camera's
input, it triggers output signals on all the associated Alarm-Out connectors. You can also have the DVR's internal buzzer
sound if motion is detected on the selected camera.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the
Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the
highlighting Notification and pressing the
that item and pressing the
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup screen and
the DVR should be registered in the RAS (Remote Administration System).
Highlight the desired box under the PTZ heading, and press the
preset position for each PTZ camera, where you want PTZ cameras to move to whenever the DVR detects motion on
the selected camera's input.

Video Loss

Highlight Video Loss in the Event menu and press the
button allows you to set up the Daytime range.
Highlight the box beside Daytime and press the
Down arrow buttons to set the Daytime range. The DVR will consider the remaining
time range as the Nighttime.
The DVR can be set to react to motion detection differently
for each camera. Each camera can be associated with another
camera, trigger an Alarm-Out connector, sound the DVR's
internal buzzer, notify a number of different devices, and/or
move PTZ cameras to preset positions.
NOTE: You can associate multiple cameras with a camera
Highlight the box under the Record heading and press the
many cameras with that camera as you wish. If the DVR
detects motion on the selected camera, it starts recording
video from all the associated cameras.
button. You can toggle the individual items On and Off by highlighting
button. Highlight OK and press the
16-Channel Digital Video Recorder
that detects motion.
button. A list of cameras appears. You can associate as
button. A list of Alarm Outputs appears. You can
button. You can toggle the entire list On and Off by
button to accept your changes.
button. A list of PTZ presets appear. Select the
button. The Video Loss setup screen appears.
button. Use the Up and
39