Network Setup; Network; Figure 20 - Network Menu; Figure 21 - Network Setup Screen - Eneo DLR-2016/500V Operating Instructions Manual

User's Manual

Network Setup

Network

Highlight Network in the Network menu and press the
Figure 21 — Network setup screen.
Highlight the box beside Remote Watch – Resolution and press the
Very High (D1), High (Half D1) and Standard (CIF). Press the
NOTE: The higher Quality and Resolution settings require higher Transfer Speed settings. The transfer speed
you set is the maximum speed. Depending on the network environment, this speed may not be achieved.
You can limit the network bandwidth settings so that system does not consume too much network bandwidth. Highlight the
box beside Network Bandwidth Limit and press the Up and Down arrow buttons to set the desired maximum bandwidth
from 10Kbps to 100Mbps.
NOTE: When limiting the network bandwidth, the remote watch image on the PC running RAS or WebGuard
might not be displayed properly.
Highlight Enable SSL for Transferring Data and press the
On, the security of data except video transmitted for remote monitoring or remote recording can be enhanced by using
the SSL (Secure Sockets Layer) authentication. When using the SSL function, the DVR cannot be connected with a
remote program or a network keyboard which does not support the SSL function.
CAUTION: The remote connection will be disconnected temporarily after changing the SSL settings.
NOTE: While the SSL function is enabled, the network transfer speed you selected may not be achieved.
This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit
(http://www.openssl.org/).
Highlight the LAN tab, and the LAN screen displays.
24
Figure 20 — Network menu.
button.
Highlight the first box beside Remote Watch – bps/ips.
Press the Up and Down arrow buttons to set the Transfer
Speed from 50Kbps to 100Mbps.
Highlight the second box beside Remote Watch – bps/ips.
You can select the unit of measure for the transfer speed
between: bps and ips. Press the
transfer speed.
Highlight the box beside Remote Watch – Quality and press
the button. You can select the Quality from: Very High,
High, Standard and Basic. Press the
Quality.
button to toggle between On and Off. When it is
button to set the
button. You can select the Resolution from:
button to set the Resolution.
button to set the