Adding IP Cameras / Encoders
MAXPRO NVR 3.1 Operator's Guide
Configuring the Cameras
Cameras are sources for a video input in MAXPRO NVR. The maximum number of cameras
that can configured in MAXPRO NVR depends on the model. You can add the following types
of cameras:
•
IP Cameras: MAXPRO NVR Wizard automatically discovers these cameras in the
network and adds it to the MAXPRO NVR user interface. See
Encoders
section for more information.
•
Analog Cameras: User is required to manually add these cameras to the respective
channel and configure the camera. See
more information. The maximum number of analog cameras that you can configure
in MAXPRO NVR Hybrid series (XE, SE, PE) is 16.
The MAXPRO NVR Wizard automatically discovers Honeywell cameras in the network and
adds it to the MAXPRO NVR user interface. Alternatively, you can also discover and add all the
supported cameras in MAXPRO NVR in the Camera page.
To add IP cameras
1.
Click the Configurator tab. The System page displays by default.
2.
Click the Camera tab to open the Camera page.
Figure 4-4
Camera page
Note:
All Honeywell cameras that are discovered and added using the MAXPRO NVR
Wizard appear in the Camera page when you first open it.
3.
Under Discover cameras here
•
Click
to discover the cameras in the network. By default, the check boxes
corresponding to all the discovered cameras are selected.
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
Adding IP Cameras /
Adding/Deleting Analog Cameras
section for
75