[Shift]; [Dot Clock]; [Clock Phase] - Panasonic PT-VW350 Operating Instructions Manual

[SHIFT]

(Only for computer signal input)
Move the image position vertically or horizontally if the image position projected on the screen is shifted even when the relative
position of the projector and the screen is installed correctly.
1) Press as to select [SHIFT].
2) Press the <ENTER> button.
f The [SHIFT] screen is displayed.
3) Press asqw to adjust the position.
Orientation
Vertical (up and down)
adjustment.
Horizontal (right and left)
adjustment.
Note
f Depending on the input signal, if the adjustment of [SHIFT] exceeds the effective adjustment range of the input signal, the
position of the image cannot be changed. Please adjust [SHIFT] within an effective adjustment range.

[DOT CLOCK]

(Only for computer (RGB) signals input)
Use this function to adjust and minimize the effect of interference caused by projection of patterns consisting of vertical stripes.
The projection of the striped pattern may cause cyclic patterns (noise). Adjust so that the amount of interference is at a
minimum. You can adjust the dot clock of image.
1) Press as to select [DOT CLOCK].
2) Press qw or the <ENTER> button.
f The [DOT CLOCK] individual adjustment screen is displayed.
3) Press qw to adjust the value.
f The adjustment values are [-32] to [+32].
Attention
f Set it before adjusting [CLOCK PHASE].

[CLOCK PHASE]

(Only for computer (RGB) signals input)
You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1) Press as to select [
2) Press qw or the <ENTER> button.
f The [CLOCK PHASE] individual adjustment screen is displayed.
58 - ENGLISH
Chapter 4 Settings - [POSITION] menu
Operation
Press the a button.
Press the s button.
Press the w button.
Press the q button.
].
CLOCK PHASE
Adjustment
The image position moves up.
The image position moves down.
The image position moves to the
right.
The image position moves to the
left.