Adjusting adjustable feet
Lift the front of the projector and press the feet lock latches on both side of the projector.
Release the feet lock latches to lock the adjustable feet and rotate the adjustable feet to a proper height and tilt.
Extend the adjustable feet by rotating in the direction shown in the figure and retract by rotating in the opposite direction.
Attention
f Heated air comes out of the air exhaust port while the lamp is lit. Do not touch the air exhaust port directly when you adjust
the adjustable feet.
f If keystone distortion occurs on the projected image, perform [KEYSTONE] from the [POSITION] menu. (x page 56)
Note
f Screw up the adjustable feet, and an audible click will be heard as the limit.
Chapter 2 Getting Started - Setting up
Feet lock latches
Adjustable range
Adjustable feet : 43 mm (1-11/16")
ENGLISH - 29