Using The P In P Function; Setting The Id Number Of The Remote Control - Panasonic PT-VW350 Operating Instructions Manual

Chapter 3 Basic Operations - Basic operations by using the remote control

Using the P IN P function

(Only for PT-VW350)
Two images can be projected simultaneously in form of projection mode (a small sub screen in the main screen [P IN P] / a
small sub screen side by side with the main screen [SIDE BY SIDE]).
button
1) Press the <P IN P> button on the remote control.
f Press this button to switch the mode ([P IN P]/[SIDE BY SIDE]).
INPUT A
Note
f For details, refer to [P IN P] (x page 67).
Switch the input source
You can switch the input source of the main screen and sub screen while the P IN P function is operating.
r Switch the input source of the main screen
Switch the input source as the same operation as the single screen.
r Switch the input source of the sub screen
When two screens are displayed (when no menu is displayed), press the <ENTER> button, the red frame of the sub screen
will be displayed. Switch the input source as the same operation as the single screen.
Press the <ENTER> button again, the red frame of the sub screen will disappear and then return to switch the input source of
the main screen.

Setting the ID number of the remote control

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector
individually by using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID ALL> button on
the remote control. Also, you can control a projector by pressing the <ID ALL> button on the remote control even if you do not
know the projector ID.
buttons
1) Press the <ID SET> button on the remote control.
2) Within five seconds, press the one-digit ID number set on the projector using the number (<1> - <6>)
buttons.
f If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the projector.
Attention
f Since the ID number of the remote control can be set without the projector, do not press the <ID SET> button on the remote
control carelessly. If the <ID SET> button is pressed and no number (<1> - <6>) buttons are pressed within five seconds, the
ID number returns to its original value before the <ID SET> button was pressed.
f The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control
is left with dead batteries. Set the same ID number again when the batteries are replaced.
Note
f Set the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID] (x page 69).
Main screen
INPUT A
INPUT B
Sub screen
Main screen
INPUT A
INPUT B
Sub screen
ENGLISH - 45