Table of Contents
Advertisement
Adjusting the focus, zoom, and lens shift
Adjust the focus, zoom, and lens shift if the image projected to the screen or its position is shifted even if the
projector and the screen are set up in the correct positions.
f When the following projection lens is used, also refer to "Adjusting the focus balance" (x page 63).
g Zoom Lens (Model No.: ET-DLE060C, ET-DLE085C, ET-DLE105C)
g Fixed-focus Lens (Model No.: ET-DLE035C)
Using the control panel
1)
Press the <镜头> button on the control panel.
f Pressing the button changes the adjustment screen in the order of [FOCUS], [ZOOM], and [SHIFT].
2)
Select each adjustment item and press asqw to adjust.
Using the remote control
1)
Press the lens buttons (<聚焦>, <变焦>, <移位>) on the remote control.
f Pressing the <聚焦> button: Adjusts the focus (adjustment of the lens focus position).
f Pressing the <变焦> button: Adjusts the zoom (adjustment of the lens zoom position).
f Pressing the <移位> button: Adjusts the lens shift (vertical position and horizontal position of the lens).
2)
Select each adjustment item and press asqw to adjust.
CAUTION
During the lens shift operation, do not insert your hand in the opening around the lens.
Your hand may be caught in between, resulting to injury.
Note
f The zoom adjustment screen is displayed but it will not operate when a projection lens with no zoom function is attached.
f When the Fixed-focus Lens (Model No.: ET-DLE055C) is used, do not adjust the lens shift and use the projector with the lens position at the
home position. (x page 64)
f The adjustment can be performed faster by holding down asqw while adjusting the focus or zoom.
f The adjustment can be performed faster by holding down asqw for approximately three seconds or longer while adjusting the lens shift.
f It is recommended to perform the focus adjustment after 30 minutes have elapsed with the focus test pattern displayed.
For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 142).
f Only [FOCUS] is displayed in yellow so that the displayed menu item can be recognized by color, even when the displayed characters are
unreadable due to incorrect focus. (Factory default)
The displayed color of [FOCUS] differs depending on the setting of the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD
DESIGN].
f When the projector is switched off during the lens shift adjustment, lens calibration needs to be performed the next time the projector is
switched on. (x page 120)
f When the main power is switched off during the lens shift adjustment, the lens calibration error screen is displayed during the next lens shift
adjustment. Execute the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION].
f When the lens calibration error is displayed even though [LENS CALIBRATION] was executed, ask your dealer to repair the unit.
62 - ENGLISH
Chapter 3 Basic Operations — Projecting
Advertisement
Table of Contents
