Powering On The Projector; When The Initial Setting Screen Is Displayed - Panasonic PT-VW350 Operating Instructions Manual

Indicator status
Lit
Green
Blinking
*1: The indicator will light as the following order:
2.75 seconds (light) → 0.25 seconds (off) → 0.75 seconds (light) → 0.25 seconds (off)
*2: The indicator will light as the following order:
2.75 seconds (light) → 0.25 seconds (off)
*3: The indicator will light as the following order:
2.0 seconds (light) → 2.0 seconds (off)
*4: The indicator will light as the following order:
0.5 seconds (light) → 0.5 seconds (off)

Powering On the Projector

Before switching on the projector, make sure all the other devices are correctly connected (x page 32) and remove the lens
cap.
1) Connect the power cord to the projector body.
2) Connect the power plug to an outlet.
f The power indicator <ON(G)/STANDBY(R)> lights or blinks, and the projector will enter the standby mode.
3) Press the power <v/b> button
f The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen.
Attention
f Be sure to remove the lens cap before starting projection.
Note
f If the [PROJECTOR SETUP] menu
seconds longer before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.

When the initial setting screen is displayed

When the projector is switched on for the first time after purchase as well as when [INITIALIZE ALL] in the [PROJECTOR
SETUP] menu is executed, then the initial setting screen is displayed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [LANGUAGE] menu.
36 - ENGLISH
Chapter 3 Basic Operations - Powering on/off
Projecting.
The power is on and the lamp is not working. The [PROJECTOR SETUP] menu x [ECO
MANAGEMENT] x [POWER MANAGEMENT] is set to [READY].
The lamp starts work. The projector will project image after a while.
on the control panel or on the remote control.
→ [ECO MANAGEMENT] → [STANDBY MODE] is set to
Status
*
3
*
4
3)
[ECO], it may take approx. 10