Panasonic PT-VW350 Operating Instructions Manual page 89

[Ping test] page
Check whether the network is connected to the mail server, POP server, DNS server, etc.
Click [Detailed set up] → [Ping test].
1 [Input IP address]
Enter the IP address of the server to be tested.
2 [Submit]
Executes the connection test.
[E-mail set up] page
When there is a problem or the runtime of a lamp reaches a set value, an E-mail can be sent to preset E-mail addresses (up
to two addresses).
Click [Detailed set up] → [E-mail set up].
1 [ENABLE]
Select [Enable] to use the E-mail function.
2 [SMTP SERVER NAME]
Enter the IP address or the server name of the E-mail
server (SMTP). To enter the server name, the DNS
server needs to be set up.
3 [MAIL FROM]
Enter the E-mail address of the projector. (Up to 63
characters in single byte)
4 [MEMO]
Enter information such as the location of the projector
that notifies the sender of the E-mail. (Up to 63
characters in single byte)
Chapter 4 Settings - [NETWORK] menu
3 Example of display when the connection has
4 Example of display when the connection has failed
5 [MINIMUM TIME]
6 [INTAKE AIR TEMPERATURE]
succeeded
Change the minimum interval for the temperature warning
E-mail. The default value is 60 minutes. In this case,
another E-mail will not be sent for 60 minutes after
sending the temperature warning E-mail even if it reaches
the warning temperature.
Change the temperature setting for the temperature
warning mail. A temperature warning E-mail is sent when
the temperature exceeds this value.
ENGLISH - 89