Panasonic PT-VW350 Operating Instructions Manual page 37

1) Press asqw to select the display language.
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (installation setting)
Set each item.
1) Press as to select an item.
Item
[PROJECTION METHOD]
[SCREEN FORMAT]*
[SCREEN POSITION]*
[HIGH ALTITUDE MODE]
*1 Only for PT-VW350.
2) Press qw to switch the setting.
3) Press the <ENTER> button to perform next initial setting.
Chapter 3 Basic Operations - Powering on/off
PT-VW350
Set [PROJECTION METHOD] depending on the installation mode.
After completed the initial setting, you can change the setting from the [PRO-
JECTOR SETUP] menu → [PROJECTION METHOD].
Set the screen format (aspect ratio) and display position of the image. After
completed the initial setting, you can change the settings of each item from the
1
[DISPLAY OPTION] menu → [SCREEN SETTING].
Set the display position of the image. After completed the initial setting, you
can change the settings of each item from the [DISPLAY OPTION] menu →
1
[SCREEN SETTING].
Change the setting when the projector is used at high altitude.
Set it to [OFF] when using the projector at altitude lower than 1 400 m (4 593'),
set it to [HIGH1] when using the projector at altitude between 1 400 m (4 593')
and 2 000 m (6 562') above sea level, and set it to [HIGH2] when using the
projector at altitude between 2 000 m (6 562') and 2 700 m (8 858') above sea
level.
PT-VX420
Description Page
70
64
64
70
ENGLISH - 37