Lamp And Warning Indicators; When An Indicator Lights Up; Lamp Indicator - Panasonic PT-VW350 Operating Instructions Manual

Lamp and Warning Indicators

When an indicator lights up

If a problem should occur inside the projector, the lamp indicator <LAMP> and the warning indicator <WARNING> will inform
you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as follows.
Attention
f Before you take a remedial measure, follow the procedure of switching the power off indicated in "Powering Off the
projector". (x page 39)
Lamp indicator <LAMP>
Warning indicator <WARNING>

Lamp indicator

Indicator Lighting in
Status Time to replace the lamp unit.
f Was [REPLACE LAMP] displayed when
you turned on the power?
f The indicator lights up when the
Check
runtime of the lamp unit has reached
5 000
set to [NORMAL]).
Remedy f Replace the lamp unit.
Note
f If the lamp indicator <LAMP> is still lighting or blinking after taking the preceding measures, ask your dealer for repair.
Warning indicator
Indicator Lighting in red.
Status Internal temperature
f Is the air intake/exhaust port blocked?
Check f Is the room temperature high?
f Is the air filter unit dirty?
f Remove any objects that are blocking the air intake
f Install the projector in a location with an ambient temperature of 0 °C
(32 °F) to 40 °C (104 °F).
Remedy
f Do not use the projector at high altitudes of 2 700 m (8 858') or higher
above sea level.
f Replace the air filter unit. (x page 99)
Note
f If the warning indicator <WARNING> is still lighting or blinking after taking the preceding measures, ask your dealer for
repair.
98 - ENGLISH
Chapter 5 Maintenance - Lamp and Warning Indicators
red.
hours (when [LAMP POWER] is
is high (warning).
Blinking in red.
A problem is detected in the lamp or the power supply for the
lamp.
f Have you turned on the
power again immediately
after turning it off?
f Wait a while until the
luminous lamp cools off,
and then turn on the power.
Blinking in red.
Internal temperature is high
(standby status).
/ exhaust port.
f Some error has occurred in
the lamp circuit. Check for
fluctuation (or drop) in the
source voltage.
f Turn off the projector, and
unplug the AC power cord,
and consult your dealer.
Blinking in red. (Slow)
The projector detects an
abnormal condition and
cannot be turned on.
_
f If the projector is turned off
again, unplug the AC power
cord and contact the dealer
or the service center for
service and checkup.