Configuring Traffic Redirecting - 3Com 4210 9-Port Configuration Manual

Configuration example
Configure port rate limiting for inbound packets on Ethernet 1/0/1.
The rate limit is 1,024 Kbps
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] line-rate inbound 1024

Configuring Traffic Redirecting

Refer to section
Configuration prerequisites
The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual for
information about defining ACL rules.
The traffic redirecting destination is determined.
Configuration procedure
You can redirect all the packets matching specific ACL rules, or packets that match specific ACL rules
and are of a VLAN, or pass a port.
Table 1-19 Redirect all the packets matching specific ACL rules
Operation
Enter system view
Configure traffic
redirecting
Table 1-20 Redirect packets that are of a VLAN and match specific ACL rules
Operation
Enter system view
Configure traffic redirecting
Table 1-21 Redirect packets passing a port and matching specific ACL rules
Operation
Enter system view
Enter Ethernet port view
Configure traffic redirecting
Traffic Redirecting for information about traffic redirecting.
system-view
traffic-redirect inbound acl-rule { cpu | interface
interface-type interface-number }
system-view
traffic-redirect vlan vlan-id inbound
acl-rule { cpu | interface interface-type
interface-number }
system-view
interface interface-type interface-number
traffic-redirect inbound acl-rule { cpu |
interface interface-type interface-number }
Command
Command
Command
1-19
Description
—
Required
Description
—
Required
Description
—
—
Required