Configuring Proxy Checking; Configuring Client Version Checking - 3Com 4210 9-Port Configuration Manual

Configuring Proxy Checking

Table 1-4 Configure proxy checking
Operation
Enter system view
Enable proxy checking
function globally
Enable proxy
checking for a
port/specified
ports
The proxy checking function needs the cooperation of 3Com's 802.1x client (iNode) program.
The proxy checking function depends on the online user handshaking function. To enable the
proxy detecting function, you need to enable the online user handshaking function first.
The configuration listed in
the switch. In addition, the client version checking function needs to be enabled on the switch too
(by using the dot1x version-check command).

Configuring Client Version Checking

Table 1-5 Configure client version checking
Operation
Enter system view
In system
view
Enable
802.1x
client
version
In port view
checking
Set the maximum number
of retires to send version
checking request packets
system-view
dot1x supp-proxy-check
{ logoff | trap }
dot1x supp-proxy-check
In system
{ logoff | trap } [ interface
view
interface-list ]
interface interface-type
interface-number
In port view
dot1x supp-proxy-check
{ logoff | trap }
quit
Table 1-4
system-view
dot1x version-check [ interface
interface-list ]
interface interface-type
interface-number
dot1x version-check
quit
dot1x retry-version-max
max-retry-version-value
Command
takes effect only when it is performed on CAMS as well as on
Command
1-17
Remarks
—
Required
By default, the 802.1x proxy
checking function is globally
disabled.
Required
By default, the 802.1x proxy
checking is disabled on a port.
Remarks
—
Required
By default, 802.1x client
version checking is disabled on
a port.
Optional
By default, the maximum
number of retires to send
version checking request
packets is 3.