Enabling The Burst Function - 3Com 4210 9-Port Configuration Manual

Table 1-25 Generate traffic statistics on packets passing a port and matching specific ACL rules
Enter system view
Enter Ethernet port view
Generate the statistics on the packets
matching specific ACL rules
Clear the statistics on the packets matching
specific ACL rules
The traffic accounting function configured on a VLAN is only applicable to packets tagged with 802.1Q
header.
Configuration example
Ethernet 1/0/1 is connected to the 10.1.1.0/24 network segment.
Generate statistics on the packets sourced from the 10.1.1.0/24 network segment.
Clear the statistics.
1) Method I: configure traffic accounting for port Ethernet 1/0/1
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-statistic inbound ip-group 2000
[Sysname-Ethernet1/0/1] reset traffic-statistic inbound ip-group 2000
2) Method II: configure traffic accounting for VLAN 2
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-statistic vlan 2 inbound ip-group 2000
[Sysname] reset traffic-statistic vlan 2 inbound ip-group 2000

Enabling the Burst Function

Refer to section
Configuration prerequisites
The burst function is required.
Operation
Burst for information about the burst function.
Command
system-view
interface interface-type
interface-number
traffic-statistic inbound
acl-rule
reset traffic-statistic
inbound acl-rule
1-22
Description
—
—
Required
Optional