Displaying Qos Profile Configuration - 3Com 4210 9-Port Configuration Manual

Configuration prerequisites
To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both globally and on
the port, and the authentication mode is determined. For information about 802.1x, refer to the
802.1x and System Guard module of this manual.
To apply a QoS profile manually, make sure the port to which the QoS profile is to be applied is
determined.
The QoS profile to be applied is determined.
Configuration procedure
Table 2-3 Configure to apply a QoS profile dynamically
Operation
Enter system view
Enter Ethernet port view
Configure the
mode to apply a
QoS profile as
port-based
Specify
the mode
to apply a
Configure the
QoS
mode to apply a
profile
QoS profile as
user-based
Table 2-4 Apply a QoS profile manually
Enter system view
In system view
Apply a
QoS profile
to specific
In
ports
Ethernet
port view

Displaying QoS Profile Configuration

After the above configuration, you can execute the display command in any view to view the running
status of the QoS profile and verify the configuration.
Table 2-5 Display QoS profile configuration
Operation
Display QoS profile
system-view
interface interface-type
interface-number
qos-profile port-based
undo qos-profile
port-based
Operation
Enter Ethernet
port view
Apply a QoS
profile to the
current port
display qos-profile { all | name
Command
—
—
Optional
By default, the mode to apply a QoS
profile is user-based.
Command
system-view
apply qos-profile
profile-name interface
interface-list
interface interface-type
interface-number
apply qos-profile
profile-name
Command
2-3
Description
If the 802.1x authentication
mode is MAC address-based,
the mode to apply a QoS profile
must be configured user-based.
If the 802.1x authentication
mode is port-based, the mode to
apply a QoS profile must be
configured as port-based.
Description
—
Select either of the
operations.
By default, a port has
no QoS profile applied
to it.
Description
Available in any view