Epson TM-C3500 Series Technical Reference Manual page 227

Die-cut label (Blackmark) / Fanfold paper
When "Borderless Printing" is disabled
Top, bottom, left, right margins: 1.5 mm (Typical value)
Center of paper width
Perforated line
Auto-cut position
Auto-cut position
Perforated line
Auto-cut position
1.5 mm
Edge cutoff 2.0 mm
 Make sure to adjust perforated lines to an integral multiple of issuing pitch.
 The perforated line and print area overlap each other to destabilize printing or perforated
line and the auto-cut position are misaligned to shorten the life of the autocutter if paper
without black marks is used. Use paper with black marks on the back of the paper to
adjust the paper position.
Paper width
Print area width
1.5 mm
Edge cutoff 2.0 mm
*1 When auto cut is not performed: 5.0 mm or more
*2 When auto cut is not performed: 8.0 mm or more
*3 When auto cut is not performed:11.0 mm or more
Chapter 6 Appendix
Paper feeding
direction
Print area
Label area
Backing paper
Black mark
position
227
5