Speaker - IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual

Speaker

Note:
Complete the following steps to remove the speaker:
1. Turn off the computer and attached devices.
2. Disconnect the power cord from the power source and from the computer; then,
3. Remove the side cover (see "Removing the side cover" on page 25.
4. Note where the speaker cable connects to the system board; then, carefully
5. Press the speaker retainer tabs to detach them from the chassis.
6. Grasp the speaker and slide it up to clear the notches, and remove it.
To install the speaker, reverse the previous steps.
70
IntelliStation Z Pro Types 6223 and 6227: Hardware Maintenance Manual and Troubleshooting Guide
v Read "Installation guidelines" on page 23.
v Read the safety notices at Appendix B, "Safety information," on page 125.
v Read "Handling static-sensitive devices" on page 23.
disconnect all external cables.
disconnect the cable from the system board.
Note: See the system service label or "System board internal connectors" on
page 72 for system board connector locations.
Speaker retainer
tabs