5. Rotate the microprocessor socket lever arm upward to its maximum vertical
6. To install a microprocessor, see "Installing a second microprocessor" on page
CD-ROM drive
Before you begin:
v Read Appendix B, "Safety information," on page 125.
v Review the information in "System reliability considerations" on page 23.
To remove the CD-ROM drive, complete the following steps:
1. Turn off the computer, if it is on.
2. Disconnect the power cord from the power source and from the computer; then,
3. Remove the side cover (see "Removing the side cover" on page 25).
4. Remove the front bezel (see "Removing the bezel" on page 26).
5. Disconnect the CD-ROM drive connector and power cables from the rear of the
6. Press the touch point on the raised area of the drive cage for the CD-ROM
For instructions for replacing the CD-ROM drive, see "Installing a drive in bay 2 or
3" on page 32.
position (135°), and lift the microprocessor up and out of the computer.
44, beginning with step 8 on page 45.
disconnect all external cables.
drive.
drive and gently slide the drive out of the front of the computer.
Lever
fully
open
Chapter 5. Field replaceable units
61