IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual page 106

Note: See Chapter 7, "Parts listing Types 6223 and 6227," on page 115 to determine which components are
replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU).
Symptom
CD-ROM drive tray is not
working. (The computer must be
powered on.)
Note: See Chapter 7, "Parts listing Types 6223 and 6227," on page 115 to determine which components are
replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU).
Symptom
The diskette drive activity LED
stays lit, or the computer
bypasses the diskette drive, or
the diskette drive does not
work.
Note: See Chapter 7, "Parts listing Types 6223 and 6227," on page 115 to determine which components are
replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU).
Symptom
Problems such as broken cover
locks or indicator LEDs not
working
Note: See Chapter 7, "Parts listing Types 6223 and 6227," on page 115 to determine which components are
replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU).
Symptom
Not all drives are recognized by
the hard disk drive diagnostic
test (Fixed Disk test).
96
IntelliStation Z Pro Types 6223 and 6227: Hardware Maintenance Manual and Troubleshooting Guide
CD-ROM drive
FRU/action
1. Insert the end of a paper clip into the manual tray-release opening.
2. Run CD-ROM diagnostics.
3. CD-ROM drive.
Diskette drive
FRU/action
1. If there is a diskette in the drive, verify that:
v The diskette drive is enabled in the Configuration/Setup utility program.
v The diskette is good and not damaged. (Try another diskette if you have
one.)
v The diskette is inserted correctly in the drive.
v The diskette contains the necessary files to start the computer.
v The software program is working properly.
v The cable is installed correctly (in the proper orientation).
2. To prevent diskette drive read/write errors, make sure that the distance
between monitors and diskette drives is at least 76 mm (3 in.).
3. Run diskette drive diagnostics.
4. Cable.
5. Diskette drive.
6. System board.
General
FRU/action
v Broken CRU/FRU
Hard disk drive
FRU/action
1. Remove the first drive not recognized and try the hard disk drive
diagnostic test again.
2. If the remaining drives are recognized, replace the drive you removed with a
new one.