IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual page 98

Note: See "System replaceable units" on page 117 to determine which components should be replaced by a field
service technician.
Error code/symptom
1800
(No more hardware interrupt available for
PCI adapter.)
1801
(No more ROM space available for PCI
adapter.)
1802
(Unavailable I/O address for PCI adapter)
1803
(Unavailable memory address for PCI
adapter)
1804
(Unavailable memory address for PCI
adapter)
1805
(PCI ROM error occurred)
1806
(PCI-to-PCI bridge error occurred)
1807
(xxxxyyyy PCI device unresponsive or
disabled by user, where xxxx=PCI vendor
ID and yyyy=PCI device ID)
1808
(Unsupported PCI device is installed)
1962
(Drive does not contain a valid boot
sector)
2400 (Video controller test failure)
88
IntelliStation Z Pro Types 6223 and 6227: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Run the Configuration/Setup Utility program.
2. Remove adapter.
1. Run the Configuration/Setup Utility program.
2. Remove adapter.
3. Disable the adapter BIOS and run the Configuration/Setup Utility
program.
1. Start the Configuration/Setup Utility program and make sure that
I/O addresses for all adapters are set correctly.
2. Adapter.
3. System board.
1. Start the Configuration/Setup Utility program and make sure that
memory addresses for all other adapters are set correctly.
2. Adapter.
3. System board.
1. Remove an adapter to make memory address space available.
2. Disable adapter BIOS on adapter.
3. Adapter.
4. System board.
1. Remove all adapters and reinstall one at a time, restarting the
computer each time, until the failing adapter is determined;
then, replace that adapter.
2. System board.
1. Remove all adapters and reinstall one at a time, restarting the
computer each time, until the failing adapter is determined;
then, replace that adapter.
2. System board.
1. Run the Configuration/Setup Utility program and make sure the
device is enabled.
2. Adapter.
3. System board.
1. Remove all adapters and reinstall one at a time, restarting the
computer each time, until the failing adapter is determined;
then, replace that adapter.
2. System board.
1. Verify that a startable operating system is installed.
2. Run diagnostics.
3. Hard disk drive.
4. SCSI backplane.
5. Cable.
6. System board.
1. Video adapter (if installed)
2. System board.