IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual page 49

12. Attach the new drive to the drive tray. Place the drive on the drive tray and
align the holes on the drive with the mounting pins on the drive tray. Gently
pull both sides of the drive tray outward and insert the mounting pins into the
holes on the drive.
13. Align the drive assembly with the guide rails in the bay (make sure that the
connector end of the drive is facing you).
14. Gently slide the drive assembly into the drive bay until the drive snaps into
place.
15. Determine whether the new drive is a Serial ATA or SCSI device; then, connect
one end of the applicable signal cable into the back of the drive and the other
end of this cable into the applicable Serial ATA or SCSI connector on the
system board. See "Power and signal cables for internal drives" on page 40 for
additional information about cabling drives and "System board internal
connectors" on page 72 for the location of the Serial ATA and SCSI connectors
on the system board. If there are open connectors on the cables connecting
existing Serial ATA or SCSI drives, you can use these cables to connect the
new drive.
16. Route the signal cable so that it does not block the airflow to the rear of the
drives or over any microprocessor.
17. Connect the power cables to the back of the drives. The connectors are keyed
and can be inserted only one way.
18. Push the drive cage outward, and press in on the drive-cage release tab; then,
rotate the drive cage back into the computer.
19. Reconnect the connector for the fan that is attached to the back of the drive
cage to the system board.
20. If you have other options to install or remove, do so now. Otherwise, replace
the side cover (see "Replacing the side cover" on page 51.
21. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Chapter 4. Installing options
39