Table of Contents
Advertisement
List of Functions
Others menu
Submenu
Set to On to monitor the projector using SNMP
SNMP
the projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is Off.
Trap IP Address
You can register up to two IP addresses for the SNMP trap
notification destination.
1/Trap IP Ad-
dress 2
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
AMX Device Dis-
When you want to allow the projector to be detected by AMX
covery
Device Discovery
connected to an environment controlled by a controller from
AMX or AMX Device Discovery.
Function
g
. To monitor
g
, set this to On. Set this to Off if you are not
Submenu
Crestron Room-
Set this to On only when monitoring or controlling the projector
View
over the network using Crestron RoomView
this to Off.
s "About Crestron RoomView
Changes in projector settings take effect upon restarting.
When this is set to On, the following functions are not available.
• Web control
• Message Broadcasting (EasyMP Monitor plugin)
Set to On if you want to enable the acquisition of the device
Control4 SDDP
information by Control4
g
(SDDP)
.
Bonjour
Set this to On when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
http://www.apple.com/
You can switch the EPSON Message Broadcasting function to
Message Broad-
enable or disable.
casting
You can download Message Broadcasting and its Operation
Guide from the following Web site.
http://www.epson.com
Reset menu
Resets all of the network settings.
120
Function
®
. Otherwise, set
®
"
p.166
®
Simple Device Discovery Protocol
Advertisement
Table of Contents
