Table of Contents
Advertisement
Problem Solving
Status
Cause
Lamp Error
Lamp Failure
Auto Iris Error
Power Err. (Ballast)
Filter Airflow Error
When using at an altitude of 1,500 m or more, set High Altitude Mode to On.
s "Extended Menu"
p.112
Check the following two points.
• Take out the lamp and check if it is cracked.
s "Replacing the Lamp"
p.148
• Clean the air filter.
s "Cleaning the Air Filter"
p.145
If the lamp is not cracked: Reinstall the lamp and turn on the power.
If the error continues: Replace the lamp with a new one and then turn on the power.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
If the lamp is cracked: Contact your local dealer or the nearest address provided in the Epson Projector Contact List. (Images cannot be
projected until the lamp is replaced.)
Epson Projector Contact List
s
When using at an altitude of 1,500 m or more, set High Altitude Mode to On.
s "Extended Menu"
p.112
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
Epson Projector Contact List
s
Check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter"
p.145
s "Replacing the Air Filter"
p.151
If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
Remedy or Status
131
Advertisement
Table of Contents
