Connecting Equipment
a
• Make the following settings to output image and audio even when the projector is in standby mode.
Set Standby Mode to Communication On.
s Extended - Standby Mode
Set A/V Output to Always On.
s Extended - A/V Settings - A/V Output
• Only analog RGB signals from the Computer port or BNC port can be output to an external monitor. You can set which signals to output in Monitor
Out.
s Extended - A/V Settings - Monitor Out
Connecting a LAN Cable
Connect a LAN port on network hubs or other equipment to the projector's LAN port with a commercially available 100BASE-TX or 10BASE-T LAN
cable.
By connecting a computer to the projector over a network, you can check the status of the projector.
p.112
p.112
p.112
Monitor Out
Audio Out
D-Sub
Audio IN
44